LUHM200 Low-power USB 2.0 to 10/100M Fast Ethernet controller is a high performance and highly integrated device which enables a small form factor, and simple plug-and-play Fast Ethernet network connection capability for desktops, notebook PC’s, Ultra-Mobile PCs, docking stations, game consoles, digital-home appliances, and any embedded system using a standard USB port.
The LUHM200 features a USB interface to communicate with a USB Host Controller and is compliant with USB specification V1.1 and V2.0. The LUHM200 implements 10/100Mbps Ethernet LAN function based on IEEE802.3 and IEEE802.3u standards with embedded SRAM for packet buffering.
For more information, please contact: sales@bluepacket.net
Features
- USB 2.0 to 10/100M Fast Ethernet controller
- USB Device Interface
- Integrates on-chip USB 2.0 transceiver and SIE compliant to USB Spec 1.1 and 2.0
- Supports USB Full and High Speed modes with Bus-Power or Self-Power capability
- Supports AutoDetach power saving, Detach from USB host when Ethernet cable is unplugged
- Integrates 10/100Mbps Fast Ethernet Controller
- IEEE 802.3 10Base-T100Base-TX compatible
- IEEE 802.3 100BASE-FX compatible
- Embedded SRAM for RX/TX packet buffering
- Supports IPv4/IPv6 packet Checksum Offload Engine to reduce CPU loading, including IPv4 IP/TCP/UDP/ICMP/IGMP & IPv6 TCP/UDP/ICMPv6 checksum check & generation
- Supports full duplex operation with IEEE 802.3x flow control and half duplex operation with back-pressure flow control
- Supports 2 VLAN ID filtering, received VLAN Tag (4 bytes) can be stripped off or preserved
- PHY loop-back diagnostic capability
- Supports Wake-on-LAN Function
- Supports Suspend Mode and Remote Wakeup via Link-change, Magic packet, MS wakeup frame and external wakeup pin
- Supports Protocol Offloads (ARP & NS) for Windows 7 Networking Power Management
- Optional PHY power down during Suspend mode
- Advanced Power Management Features
- Supports dynamic power management to reduce power dissipation during idle or light traffic period
- Supports very low power Wake-on-LAN (WOL) mode when the system enters suspend mode and waits for network event to awake it up
- The ESD protection is ± 8KV by contact and ± 15KV by air
- Supports IEC60601 MOOP (LUHM200E-A9 (MOOP))
Working voltage: 2.5KVpp
Creepage: Greater than 2.5mm
Insulation Voltage: > 1500VRMS - Supports IEC60601 MOPP (LUHM200E-A9 (MOPP))
Working voltage: 2.5KVpp
Creepage: Greater than 4.0mm
Insulation Voltage: > 1500VRMS
If you have any questions about the purchase, payment and delivery method, please contact the customer service center directly.